Pool Chemicals – Page 6

Multi Stain Remover 1KG Class 8 DG

SKU: LC-70MSR1K

Dosage:
1KG treats up to 50,000 Litres pool water

Important Notes
Avoid applying Multi-Stain Remover directly to a vinyl liner or painted surface as damage may result to the pool surface
For vinyl liner spot treatment, place Multi-Stain Remover in sock or panty hose, attach to telescopic pole and suspend over stained area
For stains throughout a vinyl liner pool, dissolve Multi-Stain Remover in a bucket of water and pour around the perimeter of the pool
After treatment a reduction in pH and/or total alkalinity may occur. If adding a pH adjuster (sodium bicarbonate) then do so very, very slowly.
Raising the pH and/or total alkalinity too quickly can cause a cloudy pool as well as re-depositing the stain back on the pool surface
Be aware that high levels of chlorine will reduce the effectiveness of Multi-Stain Remover. Ideally, reduce the chlorine level to zero before using this product

pH Increaser(Soda Ash) 2kg

SKU: LC-CC.PI.2K

Application:
Ideal pH is between 7.2 - 7.8
Broadcast over pool surface or mix in a bucket of water as per label instructions
Allow pump to run for 3hrs prior to re-testing

Dosage Rates per 10,000 Litres:
pH below 6.8 add 100grams
pH 6.8 - 7.0 add 80 grams
pH 7.0 - 7.2 add 40 grams

Pool Salt 20kg BULK CHEMICAL FREIGHT CHARGE

SKU: CH-SALT

Fast Dissolving Pool Salt – 20kg Bag.

Pureblue Granular Blackspot Killer 10kg – *DG

SKU: PP-GBS10

*PRODUCT IS DG AND CAN NOT BE SHIPPED Pureblue Granular Blackspot Killer – 900g/kg Trichloroisocyanuric Acid Controls blackspot algae in pebblecrete, plaster and tiled pools Slow release Metal free MSDS Sheet Any advice or suggestions above, including but not limited to instructions and dosing rates...

Pureblue Granular Chlorine 700 10kg – *DG

SKU: PP-GC10

*PRODUCT IS DG AND CAN NOT BE SHIPPED – AVAILABLE NSW ONLY Pureblue Granular Chlorine 700 – 700g/kg Calcium Hypochlorite For control of bacteria and algae in pools Ideal for daily treatment Highly soluble, low residue Can be used as a shock treatment MSDS Sheet...

Sensapool 10kg Alkalinity Increaser(pH Buffer)

SKU: CH-BU10K

Dosage:
200g per 10,000 Litres.
Will increase Alkalinity 10PPM

Application:
Dissolve required amount of product in a bucket of pool water and evenly distribute across the pool surface

*Dosage rates and application only a guide

Sensapool 10kg Magnesium Mineral Blend

SKU: CH-MIN10K

Dosage:
Refer to table on bag.

Application:
Pour all bag/s into the pool and allow to dissolve. Run filtration system for 12 hours to allow complete dilution.

*Dosage rates and application only a guide

Sensapool 125g Clarifying Tablet

SKU: CH-CT125G

Dosage:
1 Tablet per 50,000 Litres

Application:
Place the required number of tablets into the skimmer basket and run the filtration for 24-48 hours.
Backwash if necessary.

*Dosage rates and application only a guide

Sensapool 1kg Stabiliser(Sunscreen)

SKU: CH-PS01K

Dosage:
100g per 10,000 Litres.
Will increase cyanurate level 10PPM(mg/L)

Application:
Add required amount of product directly into the skimmer basket with the pump running

*Dosage rates and application only a guide

Sensapool 1lt Liquid Floc

SKU: CH-LF01L

Dosage:
200ml per 10,000 Litres.

Application:
Measure the correct quantity and mix in a bucket with pool water, distribute around the pool and continue running the filtration system for 1-2 hours.
Turn off filtration system and leave pool for 12-24 hours until residue settles.
Vacuum to waste, resume normal filtration

*Dosage rates and application only a guide

Sensapool 1lt Natural Clarifier

SKU: CH-NC01L

Dosage:
250ml per 30,000 Litres.

Application:
Measure the correct quantity and mix in a bucket with pool water, distribute around the pool and continue running the filtration system for min 8 hours.
Vacuum if necessary.

*Dosage rates and application only a guide